Hi there!
I recently started using UiPath and have run into an issue which is that when I use the Click activity and indicate the element that I am trying to interact with, it works some times and some times it does not.
So I tried to edit around in the UI Explorer wherein I indicate the Element & Anchor, then the Selector Editor populates the Nodes and then I click on save after successful validation.
If I close the Ui Explorer and visit the Ui Explorer for the same activity again at a later point, the Selector editor shows blank and Validate is crossed out in red. Why is it not saving is the question?
I assume that the Ui Explorer should save the data that I tweaked but it does not. The Validate button too is crossed out in red. Must be something that I am doing wrong.
It seems that you have trouble getting an answer to your question in the first 24 hours.
Let us give you a few hints and helpful links.
First, make sure you browsed through our Forum FAQ Beginner’s Guide. It will teach you what should be included in your topic.
You can check out some of our resources directly, see below:
Always search first. It is the best way to quickly find your answer. Check out the icon for that.
Clicking the options button will let you set more specific topic search filters, i.e. only the ones with a solution.
Topic that contains most common solutions with example project files can be found here.
Read our official documentation where you can find a lot of information and instructions about each of our products:
Meet us and our users on our Community Slack and ask your question there.
Hopefully this will let you easily find the solution/information you need. Once you have it, we would be happy if you could share your findings here and mark it as a solution. This will help other users find it in the future.
Thank you for helping us build our UiPath Community!