Ui Element

Help
1

{ “message”: “Attach Browser ‘iexplore.exe ACME’: Cannot find the UI element corresponding to this selector: ”, “level”: “Error”, “logType”: “Default”, “timeStamp”: “00:06:57”, “processVersion”: “1.0.0”, “jobId”: “868d6162-b919-4c68-a608-4c8b8a7295f1”, “robotName”: “TOSHIBA”, “machineId”: 0, “fileName”: “System1_Close” }

I am getting this error though my browser is getting closed post clicking on “Logout” button. This error is stopping me from next steps. Pl help

Thanks for your reply. I found that attach browser is working fine when the acme website is open. my selector looks like this

After corrections, now my selector looks like

html title=‘ACME System 1 - *’ /

but its not responding if the acme website is closed.

Any further help on this please?

2

Hi @prkumar157!

can you try click activity without recording or Attach Browser?

3

Hi @prkumar157

Make sure the selector of the log out button is working. Use the UI Explorer to generate a accurate selector. Additionally since you are using the attach browser activity, make sure that your attach browser activity selector works. If it is not configured properly if you are in a different page than the one you used to generate the selector, it can fail. So make the attach browser selector as dynamic as possible.

It should work… let know how it goes

1 Like
4

Hi Lahiru
Thanks for your reply.
It didn’t work.
I found that attach browser is working fine when the acme website is open. my selector looks like this:

but its not responding if the acme website is closed.

Any further help on this please?

5

Hi @prkumar157

Yes… For the attach browser and a selector to work, it should be active and open. Browser window can be minimized (if setup correctly) and it will work. However, it will not work if it is not at all open. May I know why are you trying to click on the logout button while the website is closed?

1 Like
6

Hey Lahiru,
I was asking about selector only, not about logout.
I am still facing the same issue. Can I share my full set of files and will you be able to guide me through to understand where I am going wrong?
Please let me know if I can share with you.

7

Hi @prkumar157

Yes… you can share your files here as a zip file. I will go through them and check where you are going wrong. :slight_smile:

1 Like
8

Thanks a lot for your support. I am uploading the entire folder. Please check and let me know if you need anything else.PRK File.zip (513.3 KB)
Also can you confirm if this certification becomes chargeable from July 1st onwards?

9

Hi Lahiru
I have shared my files with you. Hope you got them. Could you please guide me where I went wrong.
And necessary corrections. It would be of great help.