Load-Balancer Installation for Multi-Node Orchestrator Setup

1. When the DRC Passive Orchestrator (Single-Node) is already deployed, Is it ok to process the setup/installation of HAA Nodes + Orchestrator as Multi-Node, while the Load Balancer device is not yet ready? 2. On Active DC, is it possible to install Orchestrator first( Primary + Secondary), after that, install HAA Nodes? Or it has to be HAA Nodes first and then Orchestrator?

  1. When the DRC Passive Orchestrator (Single-Node) is already deployed, Is it ok to process the setup/installation of HAA Nodes + Orchestrator as Multi-Node, while the Load Balancer device is not yet ready?

Installation of HAA Nodes and Orchestrator as Multi-Node without the Load Balancer and the same can be added later.

Note: Orchestrator should run as Single-Node until Load Balancer gets configured

  1. On Active DC, is it possible to install Orchestrator first( Primary + Secondary), after that, install HAA Nodes? Or it has to be HAA Nodes first and then Orchestrator?

For Multi-Node Orchestrator, it should always be HAA Nodes first and then the Orchestrator.