UiPath Terminal Wizard. Bad display of the characters

Hello there!

This is my first post so… So forgive me if I do something that I should not

I have one question about the use of the Uipath Terminal.
Using the UiPath Terminal Wizard, and the UiPath Internal Connection, i see some characters in the terminal like “?” instead of “ñ” or “ó” …etc

Has anyone had this problem and knows how to fix it?

Thank You very much!




Depending on the Terminal you use, you could switch to an EHLL connection if possible and there you can set the encoding, that should be picked up by the wizard terminal as well.

On the UiPath Internal I’ll check if there is a workaround, I’m not sure how to get around it just yet.