We have a robot orchestrated via UiPath Orchestrator, which upon execution, consistently runs for a duration of six hours before the process terminates unexpectedly without any error notifications. It’s peculiar that the cessation occurs precisely at the six-hour mark each time. Within the “Jobs” section on the Orchestrator, the status merely displays as “State Faulted.” What could be the potential causes of this issue?
In jobs tab → for that job → Can u click on the info symbol i and check the exception message
Have a view on this knowledge base from UiPath to get this solved
Why does the job fault with the message "Job-stopped-with-an-unexpected-exit-code-0x40010004" ?
On the theoretical side it could be due to many reasons, since TerminateProcess has an exit code parameter. Practically it could have happened due to a failure in the target application itself. If UiPath is trying to access any application and the application itself is failing, in that case UiPath will not be able to interact with the application and the issue might occur. Apart from this, the same e…
Hope it’s clarified
If yes would recommend to close this topic
Forum FAQ - How to mark a post as a solution
This document is part of our beginners guide.
This article will teach you how to properly mark a post as a solution.
We were closely following our last UiPath Forum feedback round! topic and carefully extracted all the bits of feedback that was provided. As such, we would like to tackle the topic of solutions on our Forum and how to properly use them.
When is the topic resolved?
The topic can be considered resolved when the topic author has fo…
If not we can keep this thread open for the discussion
This topic was automatically closed 3 days after the last reply. New replies are no longer allowed.