Status showing as pending and nothing is happening

[Tanuja_Dongre]

Hi,
I have added few test cases onto testing tab, which were earlier getting executed but now displaying in “pending status” but nothing is happening. i have tried adding unattended testing robot and re-adding the test cases but nothing works. please help!

[Palaniyappan (Forum Leader)]

Welcome to UiPath forum

Check this knowledge base from UiPath to get this fixed

TestSet Or Testcase Execution Goes Into Pending State

Resolution when TestSet or Testcase execution goes into pending state. Issue Description: When trying to run the test set or test case it goes into pending state. Resolution: Check if Unattended Robot has been created or not. If not, enable / create Unattended Robot Make sure testing runtime is available and allocated to the Robot machine Check if the user has access to the folder. If not, add the user to the folder Check if the machine template used to connect the Robot is added to the fol…

If this is clarified and working fine
Would recommend to close this topic

Forum FAQ - How to mark a post as a solution

Forum FAQ - How to mark a post as a solution This document is part of our beginners guide. This article will teach you how to properly mark a post as a solution. We were closely following our last UiPath Forum feedback round! topic and carefully extracted all the bits of feedback that was provided. As such, we would like to tackle the topic of solutions on our Forum and how to properly use them. When is the topic resolved? The topic can be considered resolved when the topic author has fo…

If not we can still discuss further

Cheers @Tanuja_Dongre