No worries.Just need to go home .Dont worry tomorrow i will send it.
cheers
Happy learning
No worries.Just need to go home .Dont worry tomorrow i will send it.
cheers
Happy learning
Good morning @pattyricarte
Were you able to send the xaml files for my question above? Thank you again for your support.
Hi @Sugaray Good eve.
Kindly see attachment below for your reference.
Note change the path of all the necessary excel.SugarRay.zip (24.0 KB)
cheers
Happy learning :smiley
Thank you so much! I will take a look at it right now.
Good evening @pattyricarte
Could you please take a look at my xaml file? I have incorporated your steps with some steps of mine that would take place before your steps. However I am getting an error in the sequence steps “Get the Output”. The error says it can’t find the range. I used your steps and renamed some variables but it should still work right? I tried chance the Variables scopes but still no luck. Could you please tell me what I did wrong? Thank you for your help. nVision to Master Join.xaml (41.9 KB)
Ok @Sugaray
But later right now i cant access my laptop i am just replying thru mobïle.
cheers
Thank you!
Hi @Sugaray
I got the xaml but can you show some screenshot where the errors came from ?
cheers
Happy learning
Is this the value of this variable ?
In_StrOutputExcelPath
I dont see any issue on it you have sheetname and the range is there!
How about your dataable did you get value on it ?
cheers
Happy learning
So the sheet “TRP Oct 19” is created by the bot but however the data table is not added by the sequence.
Both In_StrOutputExcelPath and In_StrExcelPathSecond use the same workbook destination. I don’t get an issue while creating the out put DT of the Join Wizard from the previous sequence.