How to enable stimulate click for all click activities in the project

[Akash_Clv (Akash R)]

Hi all,

Is there is any way to enable simulate click to all click activities in UiPath by changing in one place.Rather than changing in each and every activities? . Need a detailed info regarding it .

Thanks in Advance

[raja.arslankhan]

@Akash_Clv I did not try
but i find some suggested solution

1. Open your UiPath project in UiPath Studio.
2. Go to the “Project” tab in the ribbon menu.
3. Click on “Project Settings” to open the Project Settings window.
4. In the Project Settings window, select the “Execution Target” category.
5. Under the “Input” section, locate the “Default for all activities” dropdown menu.
6. In the dropdown menu, select “Simulate” as the default input method.
7. Click “OK” to save the changes and close the Project Settings window.
   
   

[arjunshenoy]

Hi @Akash_Clv

You can try making the changes at the project level, by implementing the changes in the ‘Project Settings’ tab.

You can keep the simulate targeting type by default & it will be applied to all the click activities, unless and until overwritten at the activity level.

Hope this helps,
Best Regards.

[mkankatala (Mahesh Kankatala)]

Hi @Akash_Clv

Change the Use application\browser activity to Simulate then all of the activities which is inside the use application\browser activity. Then all the click activities are defaulty in same as application\browser option.

Hope it helps!!

[vrdabberu (Varunraj)]

Hi @Akash_Clv

While you are using use browser or application in modern experience then change the type to simulate in that particular activity so that what ever the click activities encapsulated in use application or browser all those uses the simulate type.

Regards

[lrtetala (Lakshman Reddy)]

Hi @Akash_Clv
Try this