Certification-Failed Criteria

[vinay8584 (Vinay Kumar R)]

Hi Folks, I am from non technical back ground, but a good and fast learner. Got interested in Automation, hence selected UiPath and learned it via UiPath Academy (completed 3 levels) and some videos on you tube. On my own started the certification and failed twice (Got 47 & 45 respectively). On my third attempt I got 57, means failed again. Below are the failed criteria:
Please make sure you’ve read the statement of the exercise and clearly understood it and also used the proper URL and credentials for ACME,
Please make sure you’re using the CloseAllApplications.xaml correctly as stated by the REFramework tutorial. ,
Please make sure you’re using the KillAllProcesses.xaml correctly as stated by the REFramework tutorial ,
Please make sure you have properly named your input activities.,
Please make sure you have properly named your output activities.,
Please make sure you’re correctly using the TransactionItem depending on your exercise. ,
Please make sure you’re using the TransactionData as showed in the Advanced Training.,
Please make sure you’re correctly using the TransactionData.,
Please make sure you’re not using any hardcoded values in non-xaml files.,
Please check you’re using the correct city values.,
Please make sure you’re correctly using the TransactionItem depending on your exercise.

When I run this project everything seems to be good and got the output also. The above lines (like - used the proper URL and credentials for ACME,) were taken into consideration without which my project would have not ran successfully.

Can someone help me with this, so that next time I can pass and get my certification.

[anandji05 (ANAND PRIYA TRIPATHI)]

Have you using the naming convention as per guide line? Make sure you are not hard coded any values. Follow both advanced level training assignment for KillAllProcess, CloseAllApplications etc. Check your config file.

Regards
Anand