Adding "Show/Hide Spinner" to "When Completed" rule breaks my values

[Josh_James (Josh)]

Hello,

When I add the “Show/Hide Spinner” rule to “When Completed” after I start a process, my out argument values do not send to the label boxes. They are blank. When I remove the spinner, it works fine, the labels are filled in with my out arguments. I don’t want to remove it though, because the site becomes unusable since the first spinner is still showing. If I remove that one too, it will work, but I don’t want the “start process” button to be clickable. I would prefer to have the spinner shown when the button is clicked, and have it disappear when the process finishes, but obviously I want the out arguments to go to the label boxes.

Does anyone know why the spinner breaks my values? Thanks!

[Arvind_Kumar1 (Arvind Kumar)]

@Josh_James ,

Please use start spinner before process star rule and then off spinner into completed rules and try out.

[Josh_James (Josh)]

Hello @Arvind_Kumar1 , thank you for the reply.

I think I just solved my issue a minute ago. Apparently I wasn’t waiting long enough after changes were saved to when I can preview the app. If I previewed right away after saving, the app would run the older config, so I just waited a couple minutes before previewing and it was fine.

Thanks!